Technical System Design
Independent technical consultation for new installations, plant expansions, and retrofits. I specify the correct compressor sizing, storage volume, dryer capacity, and piping for your actual demand profile, not vendor rules of thumb.
When this helps
A new installation, expansion or retrofit sized from vendor rules of thumb rather than measured demand.
What you receive
A demand assessment, documented equipment selections for compressors, storage, dryers and treatment, and a technical specification you can send to several vendors.
What the service covers
Demand assessment
A comprehensive audit of existing pneumatic consumers, leak-rate quantification, and projected growth, so the system is sized for reality.
System specification
Engineering selections for compressor type, motor sizing, receiver volume, and full air treatment, all calculations documented with references.
Bid package development
Detailed technical specifications that let you send equipment RFQs to multiple vendors and compare options without surprises.
What happens after you ask
You send a short request.
Your name, work email, company, and a few lines about the system and the problem. Nothing else is needed to start.
I reply directly.
Expect a direct reply from Peak kW within one business day.
We agree the scope in writing.
We go through your equipment, shifts, pressure needs and electricity bills. You receive a proposal that sets the measurement boundary, deliverables, fee, site access and schedule before any work begins.
I measure your system.
My loggers record power, pressure and flow across a representative operating cycle agreed in the scope.
You receive the findings and we review them together.
A prioritized action list with estimated savings, the assumptions behind every figure, and a proposed way to verify the results.
Before the first call
Have your current equipment list and expected production growth ready so we can start the demand assessment before specifying compressor, storage, and dryer sizing.
Ready to see this measured on your own system?
Every service starts with metered data from your own equipment, not a vendor's spec sheet.
Already have your equipment list to hand? Describe your facility first (optional)